We service all makes and models. Weve compiled a list of common error codes, what they mean, and what to do to resolve the problem when they are displayed. Ld (too long to drain water) appears in display. There Is a Blockage Inside the Machines Pressure Switch Hose, 3. Launch Live Chat. 1. If your Maytag washer detects excess soap suds, a SUD or SD error code will appear on the display. If you examine the solder side of the board, you can quickly pinpoint a worn-out solder joint for the relay. Set-up mode J. should be set to_d to prevent coin drop diagnostic codes.). Motor tach signal exists without motor running. It didn't bring up any lights or codes. Indicates lid is not locked. Washer is tightly packed. Make sure the water faucet are open all the way. Check for a plugged stand pipe. F03 . Check that the water supply to the washer is turned on, the hot and cold faucets are turned as far as they will go (completely open), and that water inlet valve filters are not clogged. This is a safety feature. Technically, it's called a motor rotor position sensor failure (RPS). Unplug the washer and check the wiring going to the water-heating element. Disconnect and reconnect the washer power cord at power supply outlet. Unplug the washer. Motor control board, main control board, wire harness, Communication error between the main control board and the user interface control. The washer has tried to fill, but has not reached the proper fill level. Voltage detected below 90vac for 8 seconds. /TM /*
Does Todd Mcshay Have Cancer,
Articles M